15
Using a two-gang junction box (locally procured)
• When the camera is installed using the two-gang junction box, mount the attachment plate
(accessory) to the embedded box installed on the wall or ceiling as a first step.
Note:
• For wall mounting:
Installation shall be performed in such a manner that "
TOP" of the attachment plate faces
upward.
• For ceiling mounting:
The front side (model number indication face) of the camera shall be aligned in the direction of
the arrow in "
FRONT" on the attachment plate.
WV-CW634S: Using the mounting base (accessory)
WV-CW634F: Using the mounting base WV-Q115A (option)
• When installing the camera with the mounting base WV-Q115A, attach the mounting base to
the wall or ceiling in the first place. (+ next page.)
Mount the attachment plate (accessory) by using the screws supplied with mount bracket. (+ next
page.)
(Recommended tightening torque: 0.78 N·m {0.58 lbf·ft})
Note:
• When installing the camera on the wall or ceiling where cable holes are already provided, or
when installing the camera with exposed wiring, the mount bracket shall be used.
• The female thread for conduit is compliant with ANSI NPSM (parallel pipe threads) 3/4 or ISO
228-1(parallel pipe threads) G3/4.
Cap for the female thread for the conduit shall be removed with a hexagon wrench.
• To connect conduit from the top, refer to page 18.
46 mm {1-13/16"}
83.5 mm {3-9/32"}
[Mounting position on wall or ceiling]
Attachment plate (accessory)
Two-gang junction box
FRONT
TOP
FRONT
TOP
To Next Page
Loading...
