9
y Power switch [ON]
Turns the power [On] when pushed up
and maintains this condition. Used when
talking for extended periods of time.
(☞ page 12)
u Battery cover (side)
To remove the battery cover, push it
down and pull it off.
i DC input terminal [3.3V IN]
(Underside)
Used to connect the charger (WX-LZ150)
for charging the battery installed in the
microphone and to supply power to the
microphone. (☞ page 15, 16)
o External input terminal [AUDIO IN]
(rear)
Transmits the audio from a connected
external device to the receiver.
When an external device is connected to
this terminal, audio from the q
Microphone opening is muted. (☞ page
13)
!0 Channel select switch (inside the bat-
tery cover)
Selects the microphone transmitting
channels. (☞ page 10)
!1 Battery slot (inside the battery cover)
Install one AA size nickel metal hydride
rechargeable battery or one AA/LR6 size
alkaline dry cell, paying attention to the
polarity marks (+, –) inside the battery
cover. (☞ page 11, 14)
Note:
• Use the specified charger (WX-LZ150)
for charging nickel metal hydride batter-
ies. Charging takes up to 8 hours, but the
charging time varies depending on bat-
tery type and status of use.
To Next Page
Loading...
