15
14
User manualPandora DXL-0100L/0101L service-security system
Conguring system settings via the wireless interface 2,4 GHz
To change the configuration of the system using a wireless interface 2,4 GHz, enter programming
level 10. The system will await a wireless connection from the computer for 2 minutes. If the waiting
time limit has expired and the system was not connected to the computer, it will exit this level. If the
waiting time limit has expired and the system was not connected to the computer, it will exit this
mode.
WARNING!
THIS PROGRAMMING MODE IS AVAILABLE ONLY VIA ALARMSTUDIO.
Entering the programming menu using VALET button
Level 1 Recording remotes and radio tags into the system’s memory
Level 2 Changing the factory preset service PIN-code
Level 3 Reserved
Level 4 Resetting to factory settings
Level 5 Programming RHM-02 engine compartment module
Level 6, 7 Programming radio relays 1 and 2
Level 8 Reserved
Level 9 Changing firmware via the wireless interface 2,4 GHz
Level 10 Configuring system settings via the wireless interface 2,4 GHz
Level 11 Programming validator code of immobilizer (Pin to Drive)
Level 12, 13, 14 Reserved
Level 15 Emergency disabling of immobilizer
Changing core settings via VALET button
Level 1 Recording remotes into the system’s memory
Enter the first level of programming. Remotes are recorded (paired) one by one. The pause
between recording of remotes and radio tags should not exceed 20 seconds.
To pair the radio tag, press button on the tag and hold it for 3 seconds. If the recording was
successful, the base unit will emit 1 beep, after that you can move to recording the next tag.
WARNING!
IF THE CONTROL OVER SIREN IS CARRIED OUT USING RHM02 ENGINE COMPART
MENT MODULE, SIREN SOUND SIGNALS WILL NOT BE EMITTED DURING RADIO
TAGS RECORDING!
To finish the recording of the remote units into the system, VALET button should be pressed again,
the status LED will produce series of red flashes; then switch on and off the ignition to leave the
programming mode.
Level 2 Changing the factory preset service PIN-code
• Indicator LED is not lit. Press VALET button the number of times equal to the first digit of the
new security code. Each pressing of VALET button is followed by red flash of the indicator. The interval
between the presses should not exceed 1 second.
• The input will be confirmed with red flash of indicator.
• Enter the other numbers in the same manner.
• The input of the fourth number will be confirmed by series of red LED indicator flashes.
• Enter all four numbers again.
• If you were able to correctly enter code twice, the indicator will produce series of red flashes and
a new PIN-code will be recorded, the system will return to the programming mode.
• In case of the incorrect code input the indicator will be lit red and the system will return to a
programming mode.
After the input is complete, the indicator fades, the system awaits a new programming level input.
To Next Page
Loading...
Need help?
General
