www.panduit.com 9
Operation in SmartZone
When a MAC or Trace operation is initiated in SmartZone, the corresponding beacons will illuminate
in SmartZone.
Trace Mode example
Turn on Trace Mode for any panel port in a rack where a beacon is located. As shown below, port 3
for panel 1 in rack 1 is enabled for Trace Mode.
Port 3 is connected to a panel in rack 2. The beacons on top of racks 1 and 2 in the data center will
illuminate. SmartZone will reflect the illumination in the GUI as shown below.
To Next Page
Loading...