To Next PageTo Next PageWhat to do if my Panduit TDP43HE Printer says 'No Paper'?
If your Panduit Printer indicates 'No Paper', supply a new label roll. If this doesn't solve the problem, the label might be installed incorrectly, so please refer to the user’s manual to reinstall the label roll. Also, the gap/black mark sensor may not be calibrated, so calibrate it.
General| Printer Type | Thermal Transfer Printer |
|---|---|
| Print Technology | Thermal Transfer |
| Print Resolution | 300 dpi |
| Operating System Compatibility | Windows |
| Power Requirements | 100-240 VAC, 50/60 Hz |
| Print Speed | 4 in/sec |
| Connectivity | USB, Serial, Ethernet |
| Application | Labeling |
| Supported Media Types | Continuous, Die-cut |
| Media Thickness | 0.0025 in to 0.01 in |
| Ribbon Type | Wax, Resin, Wax/Resin |
| Ribbon Length | 984 ft (300 m) |
| Operating Temperature | 41°F to 104°F |
| Humidity | 10% to 90% non-condensing |
Provides step-by-step instructions for connecting and preparing the printer for use.
Detailed instructions for installing a new ribbon roll and removing used ones.
Guides on loading internal and external media rolls, including sensor calibration.
Covers sensor status checks and calibration procedures for Gap, Bline, and Continuous media.
Setup and management of network connectivity, including IP address, DHCP, and static settings.
Guide for configuring the printer's Ethernet settings using a USB connection to the PC.
Guide for configuring the printer's Ethernet settings using an RS-232 serial connection.
Instructions for configuring Ethernet settings directly over the network interface.
Lists frequent operational problems and their corresponding recovery procedures.
