69
6.2.3.3. Configure the FTP address book
If you want to scan a file to the FTP server, you need to configure the FTP address book
first.When scanning, you may send the image scanned to the FTP server.Before configuring the
FTP address book, you may need to ask your network administrator for the server IP address,
port number, login name, password and server name.
1. Log in the embedded Web server (please refer to Chapter 6.1 for login method).
2. Click "Settings", "Machine Settings" and then "FTP Address Book" to enter the setting interface
of FTP address book.
3. Click "Create" to pop out a window as below and set relevant parameters; after settings
completed, and then click "Apply".
6.2.3.4. Sleep time setup
If you want to change the sleep time of the printer, you can set it via the embedded Web server
(the printer installed via network connection).
1. Log in the embedded Web server (please refer to Chapter 6.1 for login method).
2. Click “Settings” – “Machine settings” – “System”.
3. Select sleep time according to you need and then click “Apply”.