Pantum M7100 Series Faq

12. How to change the printing port is available when it showed” Printing port is on
used”.
"Printer cannot be configured because printing port is on used." it may cause by PC port is abnormal.
We suggest that you can check with below steps:
Step1: Change to another PC port then reconnects to the printer and re-install the driver.
Step2: Click PC table “start"-"Devices and Printers”, delete the useless printer copy manually (the mouse
right click on the useless printer name, and then delete it).
Then reconnect to the printer and re-install the driver.
Step4: please Right click “connect” in the listed printer. It will be installed the driver directly.
Step5: After done all above steps, you will see the connected printer in the “ Devices and printers”

Pantum M7100 Series Specifications

General

Functionality	Print, Copy, Scan
Print Technology	Laser
Processor Speed	600 MHz
Memory	256 MB
Duplex Printing	Automatic
Scan Type	Flatbed, ADF
Fax Function	No
Paper Input Capacity	250 sheets
Supported Operating Systems	Windows, macOS, Linux
Print Resolution	1200 x 1200 dpi
First Print Out Time	8.2 seconds
Connectivity	USB 2.0
Maximum Monthly Duty Cycle	60000 pages
Recommended Monthly Page Volume	750 - 3, 500 pages
Scan Resolution	1200 x 1200 dpi
Copy Resolution	600 x 600 dpi
Media Sizes Supported	A4, A5, A6, B5, Letter, Legal
Media Types Supported	Plain, Thick, Thin, Cardstock, Label
Print Speed	33 ppm (A4) / 35 ppm (Letter)
Copy Speed	33 cpm (A4) / 35 cpm (Letter)
ADF Capacity	50 sheets
Paper Output Capacity	150 sheets