MULTI-PRE~g
CABLE
Step 5
A.
To assemble the MULTI-PRESS CABLE (113), follow the cable routing diagram shown in drawing
and use the following steps:
*AHach one SNAP LINK I55) fo the ball end of the MULTI-PRESS CABLE (115
/
.
*Run the MULTI-PRESS CABLE (115) through the hole of the D-RING /28) as. shown
attach one KEYHOLE CLEVIS (61) to the end of the MULTI-PRESS CABLE (115).
B. A¢¢ach the CHAIN (56) fo the SNAP LINK (55) on the end of the MULTI-PRESS CABLE II15)
as shown on druwing.
C. Attach one SNAP LINK (53) fo the desired link on the CHAIN (56) , and aHach eHher
LOW ROW BAR (108) or the ANKLE STRAP (log) fo the SNAP LINK.
26
To Next Page
Loading...
