FEATURE SELECT PROGRAMMING
Addresses 062 to 126 are programmed using the Feature Select Programming method. In this method, every key on the
keypad in each address represents an option or feature. Pressing a key will display it on the keypad and pressing it again
will extinguish the key. The On/Off status of each key determines the selected feature. To program using the Feature Select
Programming method:
1) Press [
ENTER] + Installer Code (Default: 737373)
2) The [
ENTER] key will flash to indicate you are in programming mode
3) Enter 3-digit address (062-126)
4) After entering the address, the keypad will display the feature selection status. Turn the keys On/Off by pressing the
appropriate key until the desired options are set. Then press the [
ENTER
] key to accept, there will be a confirmation
"beep" indicating the options have been accepted. The [ENTER] key will flash to indicate that the software is awaiting the
next address entry
5)
Return to step 3 to continue programming or press [CLEAR
] to exit programming mode
Addresses 080 to 085 for future use.
8
To Next Page
Loading...
Need help?
General
