DECIMAL PROGRAMMING
3 Digit Decimal Value Programming
Used to program addresses 044 to 061. Values entered must contain 3 digits between "000" and "255". ([10] = 0)
Decimal value programming:
1) Press [ENTER] + installer code. ([ENTER] key will flash.)
2) Enter 3 digit address (044 to 061).
3) Current value will be displayed on keypad.
4) Enter 3 digit DECIMAL value.
5) Repeat from step 2 onward for next address.
To exit programming mode press [CLEAR].
044: ___/___/___ (hours) Auto arm time (between "000" and "023")
045: ___/___/___ (minutes) Auto arm time (between "000" and "059")
046: ___/___/___ (days) Auto test report every ? days (between "001" and "255") (000 = disabled)
047: ___/___/___ (hours) Auto test report (between "000" and "023")
048: ___/___/___ (minutes) Auto test report (between "000" and "059")
- 7 -
PG748EX
To Next Page
Loading...
Need help?
General
