Paradox SP6000 Programming Guide

Magellan & Spectra SP • Programming Guide
7
Zones
Delays
Time and Date
Walk Test Mode
Installer and Maintenance Codes
BabyWare
Monitoring Phone Number
Step Action Details
1
+ installer code
= flash; programmed zones are lit (buttons
or LED, depending on keypad); maintenance
code may also be used
2 Zone number Two digits: 01 to 32
3 Enroll or erase zone
Wireless zone: open/close cover or press
LEARN/TAMPER switch; for 2WPGM remove and
re-install Jumper 2 (JP2)
hardwired zone: press
ENTER;
to erase a programmed zone, press and hold
SLEEP for three seconds
4Zone type
See Zone Definitions on page 16, for the zone
type
5
Assign partition
(1 and/or 2 +
ENTER)
If applicable, assign the zone to one or both
partitions, and then press
ENTER; by default, all
zones are assigned to partition 1
NOTE: If applicable, partition 2 status LEDs display signal strength of selected
wireless zone (4 LEDs = best signal; 1 LED = weak signal; no LEDs = hardwired
panel/keypad zone).
Step Action Details
1
+ installer code
= flash; maintenance code may also be
used
2 -
3
1 = entry delay 1 Default: 045 sec.
2 = entry delay 2 Default: 045 sec.
3 = exit delay Default: 060 sec.
4 = bell cut-off Default: 004 min.
4 000 to 255
Entry/exit delay = seconds;
bell cut-off = minutes
Step Action Details
1
+ installer code
= flash; maintenance code may also be
used
2
+ 5 -
3 Time (HH:MM) If HH = 13 or more, go to step 5
4Time format 1 = 24 hr. format, 2 = AM, 3 = PM
5 Date (YYYY/MM/DD) Enter the year/month/day
NOTE: For SP4000 and SP65 systems, the time format must be entered in 24
hr. format, therefore, omit step 4.
Step Action Details
1
+ installer code
= flash; maintenance code may also be
used
2 -
3 6 Activates or deactivates walk test mode
Step Action Details
1
+ installer code
= flash
2 -
3
• 7 for installer
code
• 8 for
maintenance
code
-
4 Code Enter a four or six-digit code
5 Confirm code Re-enter the four or six-digit code, to confirm
NOTE: To erase a code, press and hold
SLEEP for three seconds.
Step Action Details
1
+ installer code
= flash
2 -
3 9 -
4 Phone # +
ENTER
Enter PC phone number (up to 32 digits), and
then press
ENTER
5 Panel ID Enter four-digit panel ID
6 PC password Enter four-digit PC password
NOTE: To erase the BabyWare phone number, panel ID, and PC password,
press and hold
SLEEP for three seconds.
Step Action Details
1
+ installer code
= flash
2-
3 1 -
4 Phone # +
ENTER
Enter monitoring station phone number (up
to 32 digits), and then press
ENTER
5 Partition 1 account # -
6
• 1 for CID
• 2 for SIA
SIA is not supported with GPRS/IP reporting
7 Partition 2 account # -
NOTE: To erase monitoring phone number, reporting format, and account
numbers, press and hold
SLEEP for three seconds.
Installer Quick Menu

Paradox SP6000 Specifications

General

Brand	Paradox
Model	SP6000
Category	Security System
Language	English