Spectra 1727 9
6.5.1 BYPASS RECALL
Bypass Recall allows the user to bypass the same zones that were bypassed previously at the touch of a button.
6.6 USER ACCESS CODES
The Spectra 1727 supports 9 access codes. Eight access codes are available for the users. The User Code Options are pre-programmed as
shown in
Table 4: “Pre-programmed Options for User Codes”. The options Regular Arm, Disarm, Bypass Programming, Stay Arm,
and Force Arm are explained in more detail in sections 6.1 to 6.5.
Only the Master Code can program the access code’s digits.
How do I Bypass Zones?
1) Press the [BYP] button.
2) Key in a valid [
ACCESS CODE]
3) The previously bypassed zones, if any, will illuminate.
4) Press the [
ENTER] key to accept these entries or press the key(s)
corresponding to the zones you want to change the press [
ENTER].
How do use Bypass Recall?
1) Press the [BYP] button.
2) Key in a valid [
ACCESS CODE]+
3) Press the [
BYP] button.
If desired, modify entries by pressing the button(s) corresponding to
the zones that you want to change.
4) Press [
ENTER].
How Do I Program Access Codes?
1) Press [ENTER]
2) Key in the [
MASTER CODE] (123400 by default)
3) Key in 2-digit [
SECTION] (see the Table below)
4) Key in new 4 or 6-digit [
ACCESS CODE]
[
ENTER] flashes. Return to step 3 to program another code.
5) Press [
CLEAR] to exit
How Do I Delete Access Codes?
1) Repeat steps 1 to 3 (see above)
2) Press the [
FORCE] button once for each digit in the access code
(4 or 6 times) until the keypad emits a Confirmation Beep.
To Next Page
Loading...
Need help?
General
