18 |
Magellan & Spectra SP • Installation Guide
How do I program the Auto-Arm Timer?
1. Press the [] key.
2. Enter [
MASTER CODE].
3. Press the [
BYP] key. The [BYP] key will flash.
4. Press key [1] to set partition 1, or press key [2] to set partition 2.
5. Press and hold [
SLEEP] to temporarily disable the Auto-Arm Timer.
No Movement Auto Arming
The alarm system can be programmed to arm the system and/or send a report to your monitoring station if no zone activity occurs for a pre-programmed amount
of time. This is a particularly useful feature when supervising an individual with chronic health problems or for a person who lives alone. The system will bypass any
open zones.
Display Mode
The K37 has two display modes. By default, the keypad will show all events (e.g. zones in alarm, bypassed zones, etc.) live as they occur. Alternatively, the system can
be programmed by your installer to only display zones that cause an alarm or entry delay. If you want to see the status of all zones, press the [] key. Zones that are
open but have not triggered an alarm will only be displayed after pressing the [] key. The information will be displayed for 20 seconds, showing the status of all
zones at the time the [] key was pressed. The zone display will shut off after 20 seconds. For more information on the two display modes, contact your installer.
To Next Page
Loading...
Need help?
General
