Page 15 paragonconcessions.com
NOTE: To avoid heavy build-up of deposits that require specialized cleaning, please follow these
instructions:
1. Wipe, with soft towel or cloth, excess oil from exterior and interior of kettle as often as possible.
2. Excessive or careless use of popping oil may result in kettle damage.
3. Always be sure to turn KETTLE switch to OFF when popping is complete.
NEVER USE WATER ON ANY PART OF THE KETTLE!
Sanitizing the Tubing and Pump
Reference the Oil Dispense Unit manual for oil system cleaning instructions.
Filter Cleaning
The popper is equipped with an efficient and durable filtration system. The first mesh filter should be
cleaned on a daily basis, and the two internal filters should be cleaned weekly to maintain maximum
efficiency. Follow the steps below for proper filter cleaning:
Weekly Clean the Crisper/Blower Filter (if equipped)
Follow the directions below each week to clean the crisper/blower filter. 1. Turn machine OFF, unplug
unit and allow it to cool before attempting to clean. 2. Lift off the corn pan to view the blower assembly.
3. Remove the filter bracket (held by magnet), then lift filter out and clean using warm soapy water (or
replace if needed). Rinse thoroughly and allow to dry, before reinstalling.
Clean the Crisper/Blower Compartment
The blower compartment MUST be inspected/cleaned every 3-4 months by Qualified Service Personnel
to maintain proper operation. 1. Turn machine OFF, unplug unit and allow it to cool before attempting
to clean. 2. Lift off the corn pan to view the blower assembly. 3. Remove the blower cover and if
required, carefully clean the blower compartment, and underneath the element with a vacuum only
(reference image shown). 4. After cleaning, reassemble blower cover and corn pan.
MAINTENANCE INSTRUCTIONS
Kettle Removal
1. Make sure unit is NOT connected to a power supply. UNPLUG power cord.
2. Unplug the kettle pigtail from the socket located in the chassis of the machine (ceiling).
3. Pull the clip off the hinge pin.
4. Pull the hinge pin out of the kettle hanger to free kettle.
5. TO INSTALL: Reverse steps 1-4.
Stand Removal and Installation
When using the popcorn machine on the stand, make sure to carefully place the popcorn machine on
top of the stand, lining the corners of the machine base with the stand.
To Next Page
Loading...
