STEP KEY DESCRIPTION
33. NEXT OFF is displayed with off setpoint flashing. Default value of 072F is what we
want. If another value is desired, use the +/- keys to roll to that value.
NOTE: Because the resolution is 1.5 F, not all values of F will be possible.
34. NEXT Sensor event # 02 is shown. Repeat the above steps to select sensor 1, chan-
nel 1, 12:00 PM, MON thru FRI, an ON setpoint of 077F and an OFF setpoint of
075F.
35. PROGRAM Advance to HOL (holiday) header.
36. NEXT Displays SPEC (special holiday) header.
37. - Select SPAN (holiday duration) header.
38. NEXT First holiday duration is shown with holiday # flashing.
39. NEXT Holiday start is shown with month flashing.
40. - Roll to OCT (October).
41. NEXT Holiday start date is flashing. 01 is the desired date.
42. NEXT Holiday end month is flashing.
43. + Roll to APR (April).
44. NEXT Holiday end date is flashing.
45. - Roll to 30.
46. NEXT HOLIDAY (holiday schedule) is flashing. No schedule is currently selected (not
used).
47. + Select A (holiday schedule A).
48. RUN Programming is complete. The control will do a status update and then go to
the RUN mode.
39
To Next Page
Loading...
