STEP KEY DESCRIPTION
18. + Change NO to YES to assign astro to channel 1.
19. PROGRAM Press PROGRAM key to step through headers until EVNT (event header) is
reached.
20. NEXT First event is shown with event # flashing.
21. NEXT Event type is flashing.
22. + Select ON event type.
23. NEXT Hours are flashing.
24. + Roll hours to 4 AM.
25. NEXT Minutes are flashing. 00 is desired value.
26. NEXT SUN is flashing. NO is displayed.
27. + Change NO to YES to assign this ON event to Sunday.
28. NEXT,+ Assign this ON event to MON - SAT.
29. NEXT,+,- Second event is shown with event # flashing. Program this second event as an
OFF at 11:00 PM for SUN - SAT.
30. RUN Programming is complete. The control will perform a status update before going
into the RUN mode.
42
To Next Page
Loading...
