Memory Clear
Indicates that the memory has been cleared. Use the NEXT key to begin program-
ming. After initial power-up or a reset, the control will be in MEM CLR (memory
clear) mode. This mode is only accessible once.
Toggle between MAINtAin (maintained) or MOMNtARY (momentary) operation using
the +/- key. When configured for momentary, Relay 1 will provide the ON pulse and
Relay 2 will provide the OFF pulse. An EL7200 configured for momentary operation
will become a one-channel control. Use the NEXT key to continue programming.
(The EL7100 does not have this screen.)
Toggle between 12 hour (AM/PM) or 24 hour (00:00-23:59) clock format using the
+/- key.
NOTE: After selecting relay operation and clock format, press the PROGRAM key to
begin the programming steps in the TIME header.
13
To Next Page
Loading...
