Do you have a question about the Parasound Halo JC 5 and is the answer not in the manual?
power output stereo mode 8 ohm | 400 watts x 2 |
---|---|
power output stereo mode 4 ohm | 600 watts x 2 |
power output bridged mode 8 ohm | 1200 watts x 1 |
current capacity per channel | 90 amps peak |
---|---|
slew rate | 130 volts per microsecond |
dc trigger requirements | +9 Vdc to +12 Vdc, 5 mA |
frequency response | 5 Hz - 100 kHz, +0/-3 dB |
---|---|
total harmonic distortion (thd) | < 0.05 % at full power |
im distortion | < 0.04 % |
input impedance unbalanced | 33 kΩ |
---|---|
input impedance balanced | 66 kΩ (33 kΩ per leg) |
input sensitivity for 28.28v output into 8Ω unbalanced | 1 V |
standby power requirement | 1 Watt |
---|---|
idle power requirement | 225 Watts |
maximum power requirement | 1500 Watts |
width | 17-5/8" (448 mm) |
---|---|
height without feet | 7-1/8" (181 mm) |
net weight | 73 lb. (33.1 kg) |
Covers essential safety for operation, handling, environment, power sources, and cord protection.
Details safety for repairs, damage, replacement parts, and proper unit placement to avoid hazards.
Recommendations for positioning the amplifier for optimal use, cable management, and adequate airflow.
Critical warning on matching AC voltage to the amplifier's internal setting to prevent damage.
Explains setup for higher power output to a single speaker, including impedance and mode switch.
Details DC servos, relays, current overload, and fuse protection for safeguarding amplifier and speakers.
Solutions for problems preventing the amplifier from turning on, checking settings and power.
Steps to diagnose and resolve issues when no sound is produced from the speakers.
Addresses causes of overheating and methods to eliminate background hum or hiss.
Guidance on contacting dealers or Parasound's technical service for problem resolution.