Pari Boy Pro - Multiple Patient Use

Cleaning the compressor housing
NOTE
Danger of device fault due to liquid penetration
If liquids get into the interior of the compressor, this may
cause a fault in the device.
• Never immerse the compressor in water.
• Never clean the compressor in running water.
• Never spray any liquids onto the compressor or the power
cord.
• If liquid does get into the compressor, it must not be used
under any circumstances. Before starting the compressor
again, contact the TechnicalService department or the
ServiceCenter of PARIGmbH.
Clean the compressor housing as follows:
• Wipe the outer surface of the
housing with a clean, damp
cloth.
Air filter
Take the air filter out of the compressor and inspect it at regu-
lar intervals (after every 10applications). If it is discoloured
brown or grey, or if it is damp or clogged, replace it.
The filter must be replaced after 200operating hours (ap-
prox.1year) at the latest [see:Replacing the air filter,
page34].
The air filter cannot be cleaned and then reused!
– 32 –