404/406XR Series Product Manual Appendix D - Multi-axis Configurations
46
Parker Hannifin Corporation
1140 Sandy Hill Road
Irwin, PA 15642
Appendix D - Multi-axis Configurations
Mounting Brackets
Locate the correct Mounting Bracket based on mounting configuration.
Mount X Axis or X-Y assembly to the work surface using counterbore mounting holes through the base or
appropriate toe clamps.
Orient the Z bracket according to your requirements and mount it to the carriage by inserting M6 SHCS
through the clearance holes in the bracket and into the Carriage.
Mount Z Axis 404/406XR Linear Positioner to the Z-bracket using the appropriate toe clamps or access holes
through the base where applicable.
Align the Z-axis until its axis of operation is perpendicular to the work surface.
Pinning
The following Pinning options can be selected with the 406XR:
No Pinning
X Axis Carriage dowel pin holes (requires matched Y Axis)
Y Axis Base - dowel pin holes (requires matched X Axis)
Z Axis Base dowel pinning (requires matching Z bracket)
Parker Hannifin Corporation recommends that all pinning options, which are selected, be
machined and assembled at the factory.
www.comoso.com
To Next Page
Loading...