Parker F12 series - Install Cylinder Barrel and Ensure Timing; Install Valve Plate in Barrel Housing; Install Barrel Housing and Check Backlash;Timing

15
Parker Hannin
PumpandMotorDivision
Trollhättan,Sweden
ServiceManual
Series F12
HY30-5504-M1/UK
411
Installthecylinderbarrel(item411).Ensure
correcttiming.(marking-punchmark)
Putsomegreaseonthevalveplate(item
121)andinstallitintothebarrelhousing
(item110).
Makesureyouhaveinstalledthevalve
platecorrect(seepage18).
121
110
Installthebarrelhousing(item110).
Fastentwoboltsandsecurethattheback-
lashisbetween0,1-0,3mm.Checkitwith
afeelergaugeinthedrainport.
Atthesametimedoublecheckthetiming,
(marking-punchmark).
110
.
.
.