Parker F12 series - Place End Cap onto Housing (F12-250); Pull Barrel Spindle Using Long Screw (F12-250); Fit End Cap, Shims, and Torque Screws (F12-250); Install Cap Screw Securing Barrel Spindle (F12-250)

27
Parker Hannin
PumpandMotorDivision
Trollhättan,Sweden
ServiceManual
Series F12
HY30-5504-M1/UK
Assembly F12-250
13.Placetheendcapontothebarrel
housinguntiltheO-ringisentered.
14.Fitalongscrew(M12)tothebarrel
spindleandpullthebarrelspindleup
withauniversalpliers.
15.Knockdowntheendcapwitha
plastichammerandtshims(item488)
andhexagonscrews(item493).
Torquethescrewsto330±10Nm.
16.Installthecapscrew(item428)that
securesthebarrelspindle.