Parker HTG Series - Page 30

30
Parker Hannin Corporation
Hydraulic Pump/Motor Division
Greeneville, Tennessee USA
HY13-1524-002-M1/US
Disassembly & Inspection
Service Manual
HTG Series Integrated Hydrostatic Transmission
HY13-1528-001-M1/US—HTG Series Service Manual
Disassembly and Inspection
Step
InstructionIllustration
Remove side cover.
2. Replace pulley if damaged or bent
during removal.
1. Loosen the ve screws from the side
plate using a ratchet and a 3/8” socket .
Remove pulley.
1. Use an OEM pulley puller or equivalent
standard 2-jaw or 3-jaw puller to remove
the pulley.
2. Remove ve side cover screws.
3. Remove the side cover plate.
Remove side cover gasket. 1. The gasket may either still be attached
to the inside of the side cover or sitting
on top of the housing.
2. Inspect gasket for any damage (splits or
tears). Replace if needed.