Parker HTG Series - Page 36

36
Parker Hannin Corporation
Hydraulic Pump/Motor Division
Greeneville, Tennessee USA
HY13-1524-002-M1/US
Disassembly & Inspection
Service Manual
HTG Series Integrated Hydrostatic Transmission
HY13-1528-001-M1/US—HTG Series Service Manual
Disassembly and Inspection
Step
InstructionIllustration
Remove control block The control block should slide off the
trunnion shaft. However, you may need to
use a at head screwdriver to gently loosen it.
Remove the two cradle
bushings
Remove shaft seal snap ring
1. May need to use a magnet to lift out
bushings.
2. Inspect for excessive wear, pitting or
scoring.
Using snap ring pliers, remove snap ring.
Go to Next Step