Parker HTG Series - Page 42

42
Parker Hannin Corporation
Hydraulic Pump/Motor Division
Greeneville, Tennessee USA
HY13-1524-002-M1/US
Disassembly & Inspection
Service Manual
HTG Series Integrated Hydrostatic Transmission
HY13-1528-001-M1/US—HTG Series Service Manual
Disassembly and Inspection
Step
InstructionIllustration
Remove drive link. 1. While motor housing is in vise, use
hands to gently rotate the drive link out
of the shaft.
Remove the Woodruff key.
Remove coupling shaft.
1. Gently turn the motor housing over.
2. Inspect drive link for damage and wear.
2. Using a athead screwdriver, pry off the
Woodruff key.
1. Turn motor housing back over so cou-
pling shaft is facing down.
2. Push rmly down on the motor housing
to remove coupling shaft.
3. Lift coupling shaft out through the bot-
tom of motor housing.