Parker HTG Series - Page 53

53
Parker Hannin Corporation
Hydraulic Pump/Motor Division
Greeneville, Tennessee USA
HY13-1524-002-M1/US
Assembly
Service Manual
HTG Series Integrated Hydrostatic Transmission
HY13-1528-001-M1/US—HTG Series Service Manual
Reassembly
Step
InstructionIllustration
Install housing face section
seal.
1. Apply small amount of clean grease to a
new section seal.
2. Assemble seal into the seal ring groove
of the housing face.
Install wear plate. 1. Place wear plate over drive link
2. Align wear plate bolt holes to the motor
housing bolt holes, referencing the V-
pattern previously drawn on the wear
plate.
Install section seal.
Install the assembled rotor set.
Alignment of rotor set to
housing bolt holes.
1. Install the assembled rotor set with seal
side facing down onto wear plate and
drive link thrust washer counter bore fac-
ing up
(refer to picture).
2. Verify rotor and drive link alignment
marks are aligned.
1. Apply small amount of clean grease to a
new section seal.
2. Install seal into the seal ring groove of
the rotor set.
Turn the assembly so the stator bolt holes
line up with the bolt holes of the motor
housing and the V-pattern marks.