Parker HTG Series

To Next Page

To Previous Page

Parker Hannin Corporation

Hydraulic Pump/Motor Division

Greeneville, Tennessee USA

HY13-1524-002-M1/US

Assembly

Service Manual

HTG Series Integrated Hydrostatic Transmission

HY13-1528-001-M1/US—HTG Series Service Manual

Reassembly

Step

InstructionIllustration

Oil shaft.

Insert shaft into housing.

Apply HT-1000™ oil to help shaft pass

through the lip of shaft seal package.

1. Slightly rotate shaft while pushing down

so that it passes through the seal pack-

age and bottoms on top of the thrust

washer.

2. The top of the shaft should be ush

(even) with the radial bearing face.

Install drive link. 1. Install drive link into the coupling shaft.

Install thrust bearing. Install thrust bearing over the drive link onto

the end of coupling shaft

2. Align marks on coupling shaft and drive

link.

NOTE: Refer to picture for orientation.

Parker HTG Series - Page 52