Parker HTG Series - Page 57

57
Parker Hannin Corporation
Hydraulic Pump/Motor Division
Greeneville, Tennessee USA
HY13-1524-002-M1/US
Assembly
Service Manual
HTG Series Integrated Hydrostatic Transmission
HY13-1528-001-M1/US—HTG Series Service Manual
Reassembly
Step
InstructionIllustration
Install endblock motor bolts. 1. Starting with two longest bolts, insert
one into the rst tall location on the
endblock where the lter tube hanger is
located.
2. Insert the other into the second tall loca-
tion in the endblock.
3. Place the shorter endblock bolts into the
short endblock hole locations.
4. Tighten all four bolts.
Torque bolts. Torque each bolt with torque wrench and a
9/16” socket to 45-55 ft-lbs in a cross
pattern.
Install lter.
Install side cover gasket.
2. Tighten with 15/16” wrench.
3. Torque lter to 115-135 in-lbs.
Be careful not to over torque
1. Insert lter into the top housing and twist
until hand tight.
Place the side cover gasket on top housing.