19 - EN
4.3 Stopping the generator
1 Close the ball valve on the N2 Outlet port.
2 Press to initiate the shutting down sequence.
The generator will complete the current cycle and then exhaust both beds. This may take several minutes
particularly on ppm generators.
3 When the generator is depressurised it will revert to standby mode.
4.4 Menu Interface
All of the operational parameters and data are accessed through the menu driven interface..
The interface will automatically default back to the main operating menu if no key activity has been detected for one minute.
Note: After an additional two minutes of inactivity the display will darken. To brighten the display press .