9
WARNING: This product can expose you to chemicals including lead or DEHP which are known to the state of California to cause cancer,
birth defects, and other reproductive harm. www.p65warnings.ca.gov
Catalog HY13-PMD600-SM/US
PGP/PGM 600 Series
Gear Pumps & Motors Service Manual
Disassembly Instructions
9) Next, remove the idler gear while holding down
the bottom thrust plate (Fig. 9).
Keep these gears together because they are a
matched set.
Examine each for wear and replace if
necessary.(See Wear Guide pages 18-19.)
7) Place match marks on gears before removing
(Fig. 7).
This will serve as a reference when reassembling
the motor.
8) Carefully remove drive gear rst (Fig. 8).
Avoid tapping the gear teeth together or against
other hardened surfaces.
10) Carefully remove the thrust plate from the
bottom of body (Fig. 10). Examine and replace if
necessary. (See Wear Guide pages 18-19.)
Figure 7
Figure 8
Figure 9
Figure 10
To Next Page
Loading...
Need help?
General
