16
WARNING: This product can expose you to chemicals including lead or DEHP which are known to the state of California to cause cancer,
birth defects, and other reproductive harm. www.p65warnings.ca.gov
Catalog HY13-PMD600-SM/US
PGP/PGM 600 Series
Gear Pumps & Motors Service Manual
15) Slide a lubricated steel shaft seal sleeve over the
drive gear (Fig. 17).
This will protect the gear while installing the shaft
end cover.
Assembly Instructions
16) Verify section seal is free of debris and rmly on
bottom of shaft end cover. Fit the shaft end cover
careful from the top down to the body (Fig. 18).
Make sure the interlocking track is on correctly
and line up match marks.
17) Thread the fasteners onto the body and tighten
alternately or in an X pattern (Fig. 19).
To correctly insert the back nuts and washers,
hold the shaft end cover up slightly until nuts can
be hand tightened. Then push body down rmly
to tighten front screws.
18) Tighten nuts (Fig. 20).
Begin hand tightening nuts in cross pattern,
then nish with wrench. Torque diagonally
opposed fasteners to correct torque.
Figure 17
Figure 18
Figure 19
Figure 20
To Next Page
Loading...
Need help?
General
