5.0 SciPres
®
Pressure Sensor Printout Format
23
RS-232 Output as sent to Serial Printer or Windows HyperTerminal:
03/16/09 0.51
07/07/15; Pressure v0.51; UNITS=psi ; ALARMS: HP1= 0.00; LP1= 0.00; HP2= 0.00; LP2= 0.00;
HP3= 0.00; LP3= 0.00; HTM= 0.00; LTM= 0.00;
Sensor 1 ID=S5-210246-0314; MAXP=15.90; 10/07/14; PZ=-0015; CF1= 1.035; CCF= 1.000;
CPZ=00000
Sensor 2 ID=S5-210248-0314; MAXP=17.97; 08/21/14; PZ=-0014; CF1= 1.030; CCF= 1.000;
CPZ=00000
Sensor 3 Disconnected;
RT, P1, P2, P3, TM
11:24:44, 0.04, 0.05, -.--, 0.05,
11:24:50, 0.04, 0.05, -.--, 0.05,
11:24:55, 0.04, 0.05, -.--, 0.05,
11:25:00, 0.30, 0.05, -.--, 0.17,
11:25:05, 0.28, 0.05, -.--, 0.17,
11:25:10, 0.04, 0.05, -.--, 0.04,
11:25:15, 0.29, 0.28, -.--, 0.29,
11:25:20, 0.37, 0.36, -.--, 0.36,
11:25:25, 0.32, 0.31, -.--, 0.32,
11:25:30, 0.04, 0.05, -.--, 0.05,
Abbreviations
RT = Real Time P1 = Pressure at Sensor P1
P2 = Pressure at Sensor P2 P3 = Pressure at Sensor P3
TM = Trans-Membrane Pressure DP = Differential Pressure (P1 - P2)
CF1 = Calibration Factor 1
CF2 = Calibration Factor 2 Alarm: HP1 / LP1 = Hi / Low Pressure @ P1
PZ = Zero Offset Alarm: HP2 / LP2 = Hi / Low Pressure @ P2
CP1 = Calibration Point 1 (High point) Alarm: HP3 / LP3 = Hi / Low Pressure @ P3
CP2 = Calibration Point 2 (Low Point) Alarm: HTM/ LTM = Hi / Low Pressure @ TM or DP
CCF = Custom Calibration Factor
CPZ = Custom Zero Offset -.— Indicates a disconnected sensor
Note: SciPres
®
SciDoc Software is available to collect this data automatically into an Excel
spreadsheet. See Part C.
To Next Page
Loading...