Hardware
Specifications - Monitor
Dimensions
W: 6.0¨ (15.2 cm); Height 2.75¨ (7.0 cm); D: 5.5¨ (14.0 cm)
Weight
1.5 lb (0.69 Kg)
Enclosure
Molded Plastic / Stainless Steel
Electrical
Power
110-120 or 220-240 V , 60/50 Hz AC Adaptor, 12 VDC, 500 ma Output,
Centre positive. Use only Class 2 listed AC/DC power supplies.
Operational
Range
6 to 60 ° C, 100% Humidity.
Sensor
Choice of five sizes: Luer,
3
/
8
" Barb,
1
/
2
” Barb,
3
/
4
” Tri-Clover (TC) Sanitary and 1” Tri-Clover (‘Ladish’) Sanitary.
I/O Port - 1
‘P1, P2 and P3’ Female Switchcraft 9 pin twist-lock,
connectors for sensor cables.
Note: Please use care connecting the monitor end of the sensor cable to
these ports as the male cable end can be damaged if mishandled.
I/O Port - 2
‘Output’ - Female DB25, four TTL outputs for alarms, four 4-20 ma Analog
output signals, 18 bit resolution.
I/O Port - 3
‘Printer / PC’ - Female DB9, RS-232 output for serial printer or PC.
I/O Port - 4
‘Serial I/O’ - Female DB9 (disabled).
I/O Port - 5
‘RS-485’ - 3 wire terminal block. RS-485 output (disabled).
I/O Port - 6
‘12VDC 500ma’ - DC Input for AC Adaptor.
Software
Two
Operational
Modes
Pressure
Mode
Captures stored calibration data from the sensors, digital display of up to
three pressure sensor values and either Differential or Trans Membrane
pressure, with four user-definable alarms.
Custom
Calibration
Mode
Used to perform custom calibrations, selecting User-Defined Zero
and Calibration Pressure.
8
To Next Page
Loading...