Parker V300 - Remote Communications Setup Instructions - Option 2

Bulletin 76-00 B
17
Remote Communications Setup Instructions - Option 2
Steps Setup Instructions Display Notes
1
Use the Protocol list 'MSC_114-
PURGE2_COMMUNICATIONS
TABLE' to create a Customer
Graphical User Interface.
Can set up to Integrate directly into Main control
panel.
2 Open the custom Application.
3
Connect the USB side of the USB/
RS485 cable to the computer.
4
Open the V300 Purger Controller
enclosure by unlatching the two
side latches.
5
Feed the other end of the cable
(RS845 side) through an unused
hole at the bottom of the V300
Purger Controller enclosure.
Feed from the outside to the inside.
6
Plug in the RS845 (Cat5) connector
to the RJ45 Jack on the Display
Board afxed to the backside of the
Enclosure lid.
7
Establish communication with the
V300 Purger through the custom
application.
8
Navigate the application to monitor
and set parameters as desired.
Remote Communications Setup Instructions - Option 2