Parker V300 - Factory Test Mode Instructions

Bulletin 76-00 B
34
Factory Test Mode Instructions
Steps Setup Instructions Display Notes
1
To perform a factory test, press the
(MENU) button to go to the secondary
menu screen
START UP
SELECT WITH ∨ ∧ PRESS (ENTER)
PRESS (MENU) TO RETURN
SETUP
FACTORY TEST MODE
HISTORY
MAIN MENU
LANGUAGE MENU
2
Use the (∨) button to move the selection
bar to the 'Factory Test Mode' option and
then press (Enter)
START UP
SELECT WITH ∨ ∧ PRESS (ENTER)
PRESS (MENU) TO RETURN
SETUP
FACTORY TEST MODE
HISTORY
MAIN MENU
LANGUAGE MENU
If the selection bar does not have 'Factory Test Mode'
selected, use the (
∧
) or (∨) button to move the selection
bar.
3
Enter the new password by using the
(
∧
) and (∨) buttons followed by (Enter)
for each of the four digits of the
password.
PLEASE ENTER THE PASSWORD
ADJUST WITH ∨ ∧ PRESS (ENTER)
OR PRESS (MENU) TO GO BACK
0 000
PASSWORD RESTRICTED MENU
4
Observe the Factory test sequence
initiate.
CURRENT PURGE POINT: 01
TIME LEFT ON POINT: 5
PRESS (MENU) TO CANCEL OR
PRESS (ENTER) TO ADVANCE NOW
FACTORY TEST MODE
If a failure occurs, the screen will display the failure mode.
Factory Test Mode Instructions