Parker V300 - Page 26

Bulletin 76-00 B
26
Purge Point Initiation/Termination Instructions Continued
Purge Point Initiation/ Termination Instructions
Steps Setup Instructions Display Notes
9
Use the (
∧
) or (∨) buttons to move the
selection bar to 'Terminate Purge Cycle'
and press (Enter)
TERMINATE ACTIVE POINT 01
SELECT WITH ∨ ∧ PRESS (ENTER)
PRESS (MENU) TO RETURN
TERMINATE PURGE CYCLE
TERMINATE PURGE MENU
Terminating the purge cycle will always change the
mode to Manual
10
The screen now indicates that 'No Active
Points' are present and the mode has
changed to Manual
LIQUID SOL
VENT / WATER SOL
THU MAY/21/15 04:10PM WAIT
NO ACTIVE POINTS
ACTUAL TARGET
16°F 99.3 PSIG VENT
56.4 PSIG 79.3 PSIG RESET
CYCLE HISTORY PT - -
VENTS - - - TOTAL TIME - - : - - : - -
MODE: MANUAL
12
The screen now indicates that 'Active
Point 01' has begun purging
LIQUID SOL
VENT / WATER SOL
THU MAY/21/15 04:10PM PURGING
ACTIVE POINT: 01 03:51
ACTUAL TARGET
16°F 99.3 PSIG VENT
56.4 PSIG 79.3 PSIG RESET
CYCLE HISTORY PT 01
VENTS 071 TOTAL TIME 01:45:56
MODE: AUTO