14
IE NI
• All safety and protective devices must be
properly installed and in place before the
equipment can be started.
The cutting head must be able to run
freely. Before starting the equipment, en-
sure that the cutting head is sitting correctly
and that the moving parts are free.
Warning! If there is any
doubt, seek help with the
operation of this equipment
from a specialist in an au-
thorised service centre.
Filling with Fuel
Always ensure good ventila-
tion when handling fuel.
fuel and keep away from any
when the engine is running.
Open the tank cap carefully,
so any excess pressure pre-
sent can be relieved slowly.
Start the equipment min. 3
-
sion in case of non-observance
Use only the fuel mix recommended
in the instructions. The fuel mix ages.
Therefore, do not use fuel mix that is
older than 3 months. In case of non-ob-
servance, the engine can be damaged
and the guarantee will be invalidated.
of the tank is 1200 ml.
Avoid direct skin contact with
petrol and the inhalation of pet-
rol fumes. Health hazard!
with a two-stroke en-
gine and therefore operated exclusively
with a mix of petrol and two-stroke engine
oil in the ratio 40:1.
Table of fuel mixtures:
Petrol Two-stroke oil
1,00 litres 25 ml
3,00 litres 75 ml
5,00 litres 125 ml
Mixing
40 parts of petrol
+ 1 part of oil
• Use quality unleaded petrol with an
octane rating of at least 90.
• Optimum performance will be achieved
with the use of the two-stroke engine
the equipment. If unavailable, use oil in-
tended for air-cooled two-stroke engines.
1. Prepare the petrol/oil mixture in a
clean canister intended for use with
petrol (25).
the oil, then shake the canister. Fill in
the rest of the petrol and shake the can-
ister again.
fuel mixture into the petrol tank (7).
Putting on the shoulder
strap
Always wear the carrying har-
ness when working with the
device. Always turn the device
off before taking off the carry-
ing harness. Risk of accidents.
To Next Page
Loading...
Need help?
General