Parkside PBS 2 D4 User Manual (English)

Questions and Answers:

B
Bobby PhillipsJul 30, 2025
Why Parkside PBS 2 D4 engine does not start?
- T
  Timothy MitchellJul 30, 2025
  The engine may fail to start due to several reasons. The fuel tank might be empty, requiring you to fill it with fuel. You may be using an incorrect starting sequence, so follow the instructions in the manual. The engine may be flooded; in that case, remove some gas and try starting it several times. If necessary, remove, clean, and dry the spark plug. Other possible causes include sooted spark plugs or an incorrect spark gap (clean, adjust, or replace the spark plugs), a damaged spark connection or ignition cable (replace it), dirty carburettor jets or an incorrectly adjusted carburettor mix (have it cleaned and adjusted by a specialist workshop), or a blocked fuel filter (replace or clean the fuel filter).
S
Stephen GuzmanAug 9, 2025
What to do if Parkside Trimmer engine does not give top performance?
- L
  Lauren HaynesAug 9, 2025
  If your Parkside Trimmer engine isn't performing as expected, consider these potential causes: Sooted spark plugs or an incorrect spark gap may be the issue, so clean, adjust, or replace them. A dirty air filter can also reduce performance, so clean or replace it. Additionally, dirty carburettor jets or an incorrectly adjusted carburettor mix might be the problem, requiring a specialist workshop to clean and adjust the carburettor. Ensure you are using the correct fuel mix according to the instructions. Finally, a leaking sealing ring in the crank case could be the cause, and you should have the fault corrected by a specialist workshop.
B
beth17Aug 19, 2025
Why Parkside PBS 2 D4 Trimmer has excessive formation of exhaust/ smoke?
- A
  Aaron LewisAug 20, 2025
  Excessive exhaust or smoke formation in your Parkside Trimmer can be attributed to a couple of reasons: the carburettor mix may be incorrectly adjusted, requiring a specialist workshop to clean and adjust it. Also, ensure that you are using the correct fuel mix according to the instructions.