30
GB IE
Plunge cuts are only allowed if the mitre
angle is 0°.
1. Place the saw with the front edge of the
baseplate (8) on the workpiece.
2. Turn the device on (see “Switching on/
off”).
3. Slowly saw at an angle into the work-
piece, then bring the saw into a verti-
cal position.
4. Continue sawing along the cutting line.
5. Turn off the saw and lift it off the work-
Working instructions
device for small workpieces.
which the saw blade is guided.
speed.
-
piece.
marked line, pressing the bottom plate
device. Let the device do the work.
it off and wait for it to come to a com-
plete standstill.
Cleaning and Servicing
Before carrying out work on
the device, switch it off and
unplug the mains plug.
You should have any repair and
maintenance work that is not de-
scribed in these instructions carried
out by our Service Centre. Only use
original parts.
Cleaning
The device must not be
sprayed with water or placed
in water. Otherwise there is
a risk of electric shock.
Do not use any cleaning agents or
solvents. This could damage the
device irreparably. Chemical sub-
stances may attack the plastic parts
of the device.
and handles of the machine clean.
Use a damp cloth or brush to do this.
Maintenance
The device is maintenance free.
Storage
- dry.
- clean.
- protected against dust.
- out of the reach of children.
To Next Page
Loading...
