Parkside PTK 2000 B2 - Service Center and Importer Contact Details; Importer Contact Information

3 1
G B I E
1. Blade dissolves after
switching off the engine
To slightly tightened fastening nut Tighten the right hand thread nut
2. Engine will not start a) Failure mains fuse a) Check mains fuse
b) Defective extension cable b) Replace extension cord c) Connections on motor or switch not in order c) Repair by electrical specialist d) Motor or switch faulty d) Repair by electrical specialist
3. Motor wrong direction
of rotation
a) Capacitor faulty a) Repair by electrical specialist b) Wrong connection b) Exchange polarity of outlet by an
qualied electrician
4. Motor will not work, the
fuse is activ
a) Cross section of the extension cable does
not sufciently
a) see „Electrical connection“
b) Overload by a blunt saw blade b) Change saw blade
5. Fire marks on the cutting
surface
a) blunt saw blade a) Sharpen or change saw blade b) wrong saw blade b) Change saw blade
Service-Center
Service Great Britain
Tel.: 0871 5000 720
(£ 0.10/Min.)
E-Mail: grizzly@lidl.co.uk
IAN 273460
Service Ireland
Tel.: 1890 930 034
(0,08 EUR/Min., (peak))
(0,06 EUR/Min., (off peak))
E-Mail: grizzly@lidl.ie
IAN 273460
Importer
Please note that the following address is
not a service address. Please initially con-
tact the service centre specied above.
Grizzly Tools GmbH & Co. KG
Stockstädter Straße 20
63762 Großostheim
Germany
www.grizzly-service.eu
G B
I E