Parkside PWSA 18 A1 - Application-Specific and Battery Safety

11
GB IE CY
 To charge the battery, use
only the charger supplied.
-
sures that the safety of the device
is maintained.
 Before each use, check the
charger, cable and plug
and have them repaired by

only with original parts. Do
not use a defective charger and
do not open it up yourself. This en-
sures that the safety of the device
is maintained.
 Connect the charger only to
a socket with an earth. En-
sure that the mains voltage

on the charger rating plate.
Risk of electric shock.
 Disconnect the charger from
the mains before closing or
opening connection to the
battery / power tool / de-
vice.
 Keep the charger clean and
away from wet and rain.
Do not use the charger out-
doors. Dirt and the entry of water
increase the risk of electric shock.
 Operate the charger only
with the appropriate origi-
nal batteries. Charging other
batteries may result in injuries and

 Avoid mechanical damage
to the charger. This can result in
internal short circuits.

Do not operate the charger
on a combustible surface
(e.g. paper, textiles).
due to heating during charging.
 If the power cable for this equip-
ment is damaged, it must be re-
placed by the manufacturer, a cus-
tomer service agent of the same

order to prevent hazards.
 The battery of the appliance is not
fully charged at the time of deliv-
ery. It therefore needs to be fully
recharged before you use it for

cycle we recommend that you
charge the battery for about 1
hour. Slot the battery into the base
and plug the battery charger into
a mains outlet.
 When the battery is fully charged,
unplug the charger from the mains
and from the appliance. Charging
time is approx. 1 hour.
 Do not charge the battery continu-
ously since this may damage the
battery cells. Note: Repeatedly
charging small capacities may
damage the battery cells. Re-
charge the battery only if the appli-
ance is becoming slow.
 Do not use the charger to charge
non-rechargeable batteries.
Safety instructions for all
applications
Common safety instructions for
grinding, sanding, working with
wire brushes and cutting grinders:
 
a grinder, sander, wire brush
and cutting grinder. Follow all
safety instructions, directives, il-
lustrations and facts which you
receive with the device. If you do
not follow these instructions, an electri-

may occur.