Parrot ANAFI Assembly/Disassembly Manual

ANAFI assembly and disassembly processes 17
- Insert the other arm from the same side (there is no priority order between the front and
back arms).
- -Insert the washer between the arms and make sure it is well centered (you can use a
screwdriver to align the washer through the hinge hole).
- Insert the top side hinge (the larger white part must be placed at the rear of the drone), and
make sure the hinge in completely inserted by pushing on it.
- Position the plastic holder on the lower part of the hinge with the larger extremity on the
rear side of the drone.
- -Put the screws back on the larger extremities of the hinge (one on the top side; one on the
lower side).
- -Repeat to install each arm.
- -Position antenna wires toward the front of the drone and the motor wires toward the back
of the drone.

Parrot ANAFI Specifications

General

Type	Quadcopter
Product color	Black
Housing material	Carbon
Maximum speed	55 m/s
Frequency band	2.4, 5 GHz
Number of rotors	4 rotors
Maximum weight capacity	- kg
Maximum operating distance	4000 m
Built-in processor	-
Memory card slot(s)	Yes
Compatible memory cards	MicroSD (TransFlash)
Maximum memory card size	64 GB
Megapixel	21 MP
Sensor type	CMOS
Video resolutions	3840 x 2160 pixels
Maximum frame rate	60 fps
Optical sensor size	1/2.4 \
Camera shutter speed	1 - 1/10000 s
Image formats supported	DNG, JPEG
Video formats supported	MP4
Field of view (FOV) angle	84 °
Bitrate at maximum video resolution	100 Mbit/s
Charging time	105 min
Operating time	25 min
Battery voltage	7.6 V
Battery capacity	2700 mAh
Operating temperature (T-T)	-10 - 40 °C

Weight and Dimensions

Weight	320 g