Parrot SKYCONTROLLER 2 - Wi-Fi and Sequoia Calibration; Configuring Wi-Fi Settings; Sequoia Magnetometer Calibration

23
ENGLISH
WIFI SETTINGS
1. Connect the drone using FreeFlight Pro.
2. Select Fly & Film.
3. Tap the Settings button.
4. Selection Country and press the Exterior button.
The settings are complete. It will be unnecessary to
repeat this step.
CALIBRATING SEQUOIA
Calibration of the magnetometer
The multispectral sensor ashes purple when a
calibration is required.
1. Turn the drone on the Z axis (yaw - green on the
scheme) until the multispectral sensor indicator light
ashes green.
2. Turn the drone on the Y axis (pitch - red on the
scheme) until the multispectral sensor indicator light
ashes blue.
3. Turn the drone on the X axis (roll - blue on the
scheme) until the multispectral sensor indicator light
changes colour.
> NB: Once the calibration is complete the colour of
the multispectral sensor light varies depending on
Sequoia's status. For example, if the multispectral
sensor memory is full, the indicator light will ash
yellow.