Parrot SKYCONTROLLER 2 - Drone Connectivity and Calibration; Pairing Drone and Skycontroller; Drone Calibration Procedure

22
CONNECT THE
DRONE TO PARROT
SKYCONTROLLER 2
1. Place Parrot Bluegrass on a at surface.
2. Turn on your Parrot Bluegrass.
3. Press the Parrot Skycontroller 2 ON/OFF button to
turn it on.
4. Wait patiently until the Parrot Skycontroller 2 indicator
light is steady green.
> You are connected to Parrot Bluegrass, advance to
drone calibration and Wi-Fi® settings.
> Warning the geobarrier on FreeFlight Pro limits the
distancing of the drone when this option is activated:
set a geobarrier distance slightly larger than the ight
zone.
CALIBRATE THE DRONE
It is recommended to calibrate the drone before each
ight using the FreeFlight Pro app.
If the app displays a window requesting drone
calibration, follow the steps shown on the screen.
You can also calibrate the drone manually:
1. Select Parrot Bluegrass in the Freeight Pro app.
2. Press the Calibration button on the information page
on the drone.
3. Follow the on-screen animation.
> The animation disappears when calibration is com-
pleted; you can then start the ight plan on Pix4D-
capture.