47
2. Prepare a suitable container that holds a larger amount than the engine oil capacity. Loosen and
remove the drain screw while holding the container under the drain hole. Then remove the oil filler cap.
Let oil drain completely. Wipe up any spilled oil immediately.
3. Put a new gasket on the oil drain screw. Tighten the drain screw.
4. Add the correct amount of oil through the filler hole. Install the filler cap.
5. Start the engine and make sure that there are no oil leaks.
6. Turn off the engine and wait 3 minutes. Recheck the oil level using the dipstick to be sure the level
falls between the upper and lower marks.
CAUTION:
The oil should be changed more often when the engine is operated under adverse conditions
such as extended trolling.
To Next Page
Loading...
