30
2.12 Warning indicators and solutions
The engine equips oil pressure warning indicator and water temperature warning indicator.
If the oil pressure becomes too low (insufficient engine oil) or too high (too much engine oil) when engine
speed is over 2200rpm, the oil pressure warning indicator will be activated, and the engine will enter into
the protection status, which limits the rpm. In such status, please stop the engine as soon as it is safe to
do so, and check the engine oil level.
NOTE:
1. Check the oil level. Add oil as needed if insufficient oil, or drain out extra if too much oil. Refer
to section 2.3.
2. If the oil level is proper and the warning device does not switch off, consult your dealer.
If the water temperature rises too high when engine speed is over 2200r/min and lasts for over 20 seconds,
the water temperature warning indicator will light or blink. The engine is in protection status and engine
speed will be limited until the water temperature returns to the normal condition and lasts for over 10
seconds.
NOTE:
Please check the cooling water pilot hole if the temperature warning indicator keeps on:
1. Please check the cooling water inlet and pilot hole if there is no water flow. Clean them if
clogged. Otherwise, please consult your dealer.
2. Please consult your dealer if there is the normal flow of cooling water.
https://www.boat-manuals.com/
To Next Page
Loading...
Need help?
General
