48
4.3 Flusher
Perform this procedure right after operation for thorough flushing.
CAUTION:
Do not perform this procedure while the engine is running. The water pump may be damaged from
overheat, or serious damage can occur
1. After stopping the engine, remove the water pipe connector from the water pipe plug.
1. Water pipe plug; 2. Water pipe connector
2. Connect the water pipe connector to a rubber hose connecting to clean fresh water, and turn on the tap.
3. Flush the fresh water through the cooling passage for about 15 minutes. Turn off the water and remove
the water pipe connector.
4. Install the water pipe connector onto the water pipe plug after flushing. Tighten the nut.
21
https://www.boat-manuals.com/
To Next Page
Loading...
Need help?
General
