ASSEMBLING
Reverse the steps of disassembling.
INSTALLATION
1. Put starter onto the power unit.
2. Screw the hexagon bolt, and tighten it according to the specified torque.
3. Install the detent tightwire.
4. Adjust the adjusting nut on the tightwire of the dent, and align the triangle marking of the dent
with the triangle marking of the starter case.
1. Triangle mark
2
1
3
2
2. Adjusting nut
3. Detent tightwire
26
https://www.boat-manuals.com/
To Next Page
Loading...
