4． Remove cotter pin and friction adjusting bolt.
5． Remove steering handle.
6． Remove throttle cable.
7． Remove throttle lever stay and throttle lever.
8． Remove engine stop switch.
9． Inspect if steering handle is cracked or damaged. Replace if necessary.
10． Inspect if bush, bush washer and wave washer are cracked or damaged. Replace if
necessary.
11. Inspect if steering handle shock damper is cracked or damaged. Replace if necessary.
12.
Inspect if throttle cable is cracked or damaged. Replace if necessary.
13. Inspect the conduction of engine stop switch. If not to specification, replace it.
Remove lockplate: Conducting
Install lockplate: Not conducting
Push stop switch button: Conducting
67
https://www.boat-manuals.com/
To Next Page
Loading...
