TITLE : RP-300/310
Page -63 -
①When the starting position is set to the upper left or lower right, this
command sets the absolute position in the vertical direction.
②When the starting position is set to the upper right or lower left, this
command sets the absolute position in the horizontal direction.
·The horizontal and vertical motion units are specified by GS P.
·The GS P command can change the horizontal and vertical motion unit.
However, the value cannot be less than the minimum horizontal
movement amount, and it must be in even units of the minimum
horizontal movement amount.
[Reference] ESC $, ESC T, ESC W, ESC ＼, GS ＼, GS P
GS ∗ x y
d1...d
(x × y × 8)
[Name] Define downloaded bit image
[Format] ASCII GS ∗
x
y
d1
…
d
(
x
x
y
x 8)
Hex 1D 2A
x
y
d1
…
d
(
x
x
y
x 8)
Decimal 29 42
x
y
d1
…
d
(
x
x
y
x 8)
[Range] 1 ≤
x
≤ 255
1 ≤
y
≤ 48
x
x
y
≤ 1536
0 ≤
d
≤ 255
[Description] Defines a downloaded bit image with the number of dots specified by
x
and
y
.
·
x
indicates the number of dots in the horizontal direction.
·
y
indicates he number of dots in the vertical direction.
[Details] ·The number of dots in the horizontal direction is
x
x 8, in the vertical
direction it is
y
x 8.
·If
x
x
y
is out of the specified range, this command is disabled.
·The d indicates bit-image data. Data
(d)
specifies a bit printed to 1 and
not printed to 0.
·The downloaded bit image definition is cleared when:
To Next Page
Loading...
